Revision history [back]

There could be several reasons why the breakpoint is not being triggered when attempting to debug a unit test in Maven. Here are a few possible solutions:

1. Make sure that you are actually running the unit test in debug mode. You can do this by adding the following command-line argument to your Maven invocation: -Dmaven.surefire.debug. Check that the debugger is attached by looking for the Listening for transport dt_socket at address: 8000 message in the console output.

2. Ensure that the breakpoint is being set in the correct place. If you set the breakpoint on a line that is not executed during the test run, it will not be triggered. Make sure that the breakpoint is set on a line that you know will be executed during the test.

3. Verify that the code being tested is being executed from the unit test. Sometimes, if the code under test is not being executed (for example, if it is being mocked out), then the breakpoint will not be triggered. Check that the code you are trying to debug is actually being executed by the test.

4. Make sure that your IDE and debugger are set up correctly. Verify that your IDE is properly configured to use the debugger, and that the debugger settings are correct. Some IDEs, such as IntelliJ IDEA, require special configuration to properly debug Maven unit tests.

5. If none of the above solutions work, try adding additional logging to your code to help you isolate the problem. This can help you identify where the test is failing, which can in turn help you fix the breakpoint issue.