Revision history [back]

To save a memory location in RISC-V, you need to store the data from a register to a memory location using a store instruction. The steps are as follows:

1. Load the data into a register using load instructions like "lw".

2. Calculate the memory location address by adding an offset to the base address using arithmetic instructions like "addi".

3. Store the data from the register to the memory location using store instructions like "sw".

For example, if you want to save the value of register $t0 to memory location 0x1000, you can use the following RISC-V code:

lw $t1, 0($t0) # Load the value from register $t0 to $t1 addi $t2, $zero, 0x1000 # Calculate the memory address as 0x1000 sw $t1, 0($t2) # Store the value from $t1 to memory location 0x1000